Connect X1 controller at headphone

cpaglietti

Please someone know how connect X1 MK3 with headphones to pre-listening?thank you.

Sunborn

https://community.native-instruments.com/discussion/18489/connect-x1-controller-at-headphone

It is not possible directly through an X1, you need to use some kind of audio device.

For possible solutions, check here:

https://www.native-instruments.com/en/products/traktor/dj-controllers/traktor-x1/

Scroll down the page until you reach the "Setup examples" section. :-)

cpaglietti

Audio 2 MK2 is it compatible?

Sûlherokhh

https://community.native-instruments.com/discussion/comment/106769#Comment_106769

Yes. I use it all the time.

Sunborn

https://community.native-instruments.com/discussion/comment/106769#Comment_106769

Any audio device with 2 outputs should be compatible.

lord-carlos

Or use the "Traktor DJ Cable"

Then you will have two mono out https://www.native-instruments.com/en/products/traktor/traktor-for-ios/traktor-dj-cable/

cpaglietti

lord Carlos, Thank you, please could give me also information how to config Traktor pro to use this cable ?

Thank you

Carlo

lord-carlos

https://community.native-instruments.com/discussion/comment/107197#Comment_107197

Sure.

Here you go: https://support.native-instruments.com/hc/en-us/articles/209576269-How-to-Use-the-TRAKTOR-DJ-Cable-with-TRAKTOR

cpaglietti

At the end I have bough a Volt 1 audio device but I’m in trouble: I selected de Volt1 like audio but I can’t see different channel to play music and monitoring. Any suggestion?

Thank you

Carlo

lord-carlos

https://community.native-instruments.com/discussion/comment/107320#Comment_107320

That one only has 2 channels. Left and right. You need 4, two stereo channels.

Volt 4 might work.