Traktor Pro Recall last state on launch

Jamieeee

Hi. I'm new to Traktor. I know it doesn't have a normal save and load project paradigm as most software.

However, when I was first using it I could load files into my decks, set aspects of the samples etc, then when I'd reopen Traktor they would already be in there loaded and able to use, with the settings I’ve had recalled.

I'm now not able to do this - when I open my project the decks are blank and I have to drag in my samples and manually go about setting loop lengths etc again.

Does anyone know how I make it so that it'll just reload like it used to? I've scoured preferences and had a good look online and found very little.

Thanks!

I'm running latest traktor pro btw on macOS

Sunborn

https://community.native-instruments.com/discussion/18058/traktor-pro-recall-last-state-on-launch

"when I open my project the decks are blank and I have to drag in my samples and manually go about setting loop lengths etc again."

This is normal behavior, but, if you save playlists, they will be there, with all your settings, when you re-open Traktor. If there are no playlists, then Traktor has nothing to show, thus you see the blank pages.

However, opening Traktor and then it automatically load tracks on decks, was never an option!