Maschine studio hangs on startup screen

bearded_dev

so when i google i find an old post about this it seems but when i click through it isnt on here.

basically as the title, it lights up all the colors phase across then just hangs on the maschine - groove production screens... Any advice, is there a hard reset of the hardware ?

darkwaves

https://community.native-instruments.com/discussion/comment/58716#Comment_58716

It's not a midi controller in that sense. You need a few services that are usually installed with the maschine software, controller editor, driver, etc.

Reefius

I could be wrong, but I don't think there is anything wrong with the Maschine Studio hardware. I believe this is a software issue or a bad USB cable.

Is the Maschine software properly installed? If so, try using another USB cable.

bearded_dev

I have tried a few different cables so that doesnt seem to be the issue, the controller should boot in to midi mode though regardless of the maschine software being installed right ?

darkwaves

https://community.native-instruments.com/discussion/comment/58716#Comment_58716

It's not a midi controller in that sense. You need a few services that are usually installed with the maschine software, controller editor, driver, etc.

Jeremy_NI

@darkwaves is absolutely right! In case it does not work, check this article:My MASCHINE Controller Does Not Start