Phil Collen output too high???

leppmix · April 2023

Hey all I'm v new to this.

Running GR6 as a standalone. Soundcard is Focusrite solo,

I'm using the Phil Collen METAL RACKET and the right channel is full of interference even when noting is pugged in. its pushing out about 25% noise that's registering on the output meter.

Any ideas?

ta!

A

Brad Yost · April 2023

Are you using the ASIO drivers for your Focusrite?

LostInFoundation · April 2023

Isn’t metal all about distortions and interferences? 😂

Jokes apart it could be a problem of the interface. Try loading GR as an fx on a daw’s track with some audio to see if it’s giving problems anyway

leppmix · April 2023

i just plugged teh FOCUS RITE in. do i need to DL drivers?

LostInFoundation · April 2023

https://community.native-instruments.com/discussion/comment/63820#Comment_63820

If it is class compliant no. And if you are on windows they should install automatically.

But Brad Yost was suggesting to try Asio drivers so you can compare to see where the problem is

LostInFoundation · April 2023

@leppmix Maybe I found something that could be pertinent and useful for you.

Do you know which generation is your Solo? Because it seems 1st and 2nd gen are not class compliant and therefore it would be better to install its official driver.

Otherwise:

(Source: https://support.focusrite.com/hc/en-gb/articles/115002520325-Are-Focusrite-USB-interfaces-Plug-and-Play-on-Windows-)

LostInFoundation · April 2023

In few words: if your Solo is 1st or 2nd gen and you didn’t install its drivers, it will work anyway but with a generic Microsoft driver that could cause problems

Phil Collen output too high???

Comments

Categories