RX11 Standalone not processing audio through modules

RussellS
RussellS Member Posts: 3 Newcomer
in Other Software & Hardware

So I've installed (and re-installed) RX11. No previous versions are installed. I can load and listen to audio in the standalone but the modules are not processing anything. The individual modules, that are available, in ableton work fine. System requirements are more than enough. No error messages come up.

I'm hoping I'm just green and missing a simple button but I thought it was ready to go young install. Customer service is taking its usual time so I thought I'd try here. Any ideas? Thank you in advance.

Tagged:

Best Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,630 mod
    Answer ✓

    Hello,

    if you open up a module you have the render button on the lower right, you can also open up the chain module (top right; or press "c"), add modules there and render them all at once. Then there is also the possibility of using the batch processor.

  • Vocalpoint
    Vocalpoint Member Posts: 3,815 Expert
    Answer ✓
    https://community.native-instruments.com/discussion/comment/226908#Comment_226908

    Sure can. Each module has a Preview button in the lower left.

    But you need to understand that RX is designed to be a "spot" toolkit - where you find problems within an audio file that need a little TLC - you select (highlight) a problem area - select a single plugin (or chain a few together in Module Chainer), make some adjustments within the plugin (s) in it, preview those adjustments and then render those adjustments into the file and then move on to the next.

    For "global" adjustments - like say you want to EQ the entire file - it's best to use the Batch Processor.

    VP

Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,630 mod
    Answer ✓

    Hello,

    if you open up a module you have the render button on the lower right, you can also open up the chain module (top right; or press "c"), add modules there and render them all at once. Then there is also the possibility of using the batch processor.

  • Vocalpoint
    Vocalpoint Member Posts: 3,815 Expert
    https://community.native-instruments.com/discussion/45238/rx11-standalone-not-processing-audio-through-modules

    @Uwe303 has it correct.

    RX is not "Realtime" - so loading an audio file and adding a few modules to it - is not like a DAW where you hear what those plugins are doing by hitting Play.

    In RX you need to "render" everything and then play it back.

    VP

  • RussellS
    RussellS Member Posts: 3 Newcomer

    So there's no way to preview the adjustments in making within the module?

  • Vocalpoint
    Vocalpoint Member Posts: 3,815 Expert
    Answer ✓
    https://community.native-instruments.com/discussion/comment/226908#Comment_226908

    Sure can. Each module has a Preview button in the lower left.

    But you need to understand that RX is designed to be a "spot" toolkit - where you find problems within an audio file that need a little TLC - you select (highlight) a problem area - select a single plugin (or chain a few together in Module Chainer), make some adjustments within the plugin (s) in it, preview those adjustments and then render those adjustments into the file and then move on to the next.

    For "global" adjustments - like say you want to EQ the entire file - it's best to use the Batch Processor.

    VP

  • RussellS
    RussellS Member Posts: 3 Newcomer

    Thankyou. This is what I was looking for. Knew I was just missing something small. I'll give it a shot when back in the studio

Back To Top

Categories