My Maschine Mikro MK3 is not detected as midi device anymore, Can this be Hardware failure ?

Arnaud Rosenstingl · January 31

I use Maschine usualy as a pluggin in Reaper, with my MikroMK3 set as a midi controler.

Today when I tried to add Maschine in a track in reaper the controler didn't turned on.

I tried to reinstall controler editor, then the driver, then Maschine itself but nothing worked.

Finaly I found that the NIHhostintegration agent had stopped. I restarted it and the controler connected itself in Maschine or with the controler editor.

But Maschine dont shows up anywhere (Reaper/Komplete Control/midiview) as a detected Midi device.

I can Put My Maschine Mikro in midi mode , but the signal seems to go nowhere.

The hardware is detected By windows as a USB device but not as a midi device.

What did I miss ?

(I tried to connect it on my laptop, but the problem is the same)

Uwe303 · February 1

Hello,

You could try to go into the device manager, set it to show all devices, disconnect maschine. Then you delete all maschine related devices, if asked for deleting the driver's, say yes. Then reinstall the driver's and reconnect maschine.. sometimes it helps to install this:

https://www.bome.com/products/bmidi

It's a virtual midi cable, used by native instruments

Arnaud Rosenstingl · February 1

Thanx a Lot UwE303,

It worked perfectly :)

Und Danke auch fur die Musik ! (Ich lerne gerade Deutsch !) 😃

Arnaud Rosenstingl · January 31

Hello By the way :)

Uwe303 · February 1