How can I enable the Shift Page functionality on my Kontrol F1 using Rebekah's custom mapping

Hi everyone,

I’m having trouble setting up my Traktor Kontrol F1 using Rebekah’s custom mapping, and I’d appreciate your advice. Here’s what’s happening:

1. I successfully imported the Rebekah Traktor Mapping.tsi and Rebekah Effect Settings.tsi files into Traktor. The Basic Page of the mapping works fine, and all controls respond as expected.
2. However, when I press the Shift button on the F1 to access the Shift Page, all 16 pads light up yellow, and none of them respond to input.
3. I checked the Controller Manager:
   • The Assignment Table appears as expected for the Basic Page.
   • For the Shift Page, there seems to be no functional response.
4. In the Controller Editor, the pad color yellow is set to "Off", which seems to indicate the pads are inactive. Is there a way to activate them, or am I missing something in the configuration?

What I’ve Tried:

• I verified the ports are correctly set to Traktor Kontrol F1 in the Controller Manager.
• I reimported the mapping files in the order: Rebekah Traktor Mapping.tsi first, followed by Rebekah Effect Settings.tsi.
• I loaded the .nckf1 file in the Controller Editor and checked the settings, but the issue persists.
• I tested the Shift button modifier, but there’s no functional response.

System Info:

• Traktor version: 4.1.1 23
• OS: macOS Sequoia 15.1.1
• F1 firmware: 0.11

Has anyone else experienced this issue with Rebekah’s mapping or similar setups? Are there additional steps I should take to enable the Shift Page functionality? Any help would be greatly appreciated!

Thanks in advance!
Chris