Hi everyone,
I’m having trouble setting up my Traktor Kontrol F1 using Rebekah’s custom mapping, and I’d appreciate your advice. Here’s what’s happening:
- I successfully imported the
Rebekah Traktor Mapping.tsi
and Rebekah Effect Settings.tsi
files into Traktor. The Basic Page of the mapping works fine, and all controls respond as expected. - However, when I press the Shift button on the F1 to access the Shift Page, all 16 pads light up yellow, and none of them respond to input.
- I checked the Controller Manager:
- The Assignment Table appears as expected for the Basic Page.
- For the Shift Page, there seems to be no functional response.
- In the Controller Editor, the pad color yellow is set to "Off", which seems to indicate the pads are inactive. Is there a way to activate them, or am I missing something in the configuration?
What I’ve Tried:
- I verified the ports are correctly set to Traktor Kontrol F1 in the Controller Manager.
- I reimported the mapping files in the order:
Rebekah Traktor Mapping.tsi
first, followed by Rebekah Effect Settings.tsi
. - I loaded the
.nckf1
file in the Controller Editor and checked the settings, but the issue persists. - I tested the Shift button modifier, but there’s no functional response.
System Info:
- Traktor version: 4.1.1 23
- OS: macOS Sequoia 15.1.1
- F1 firmware: 0.11
Has anyone else experienced this issue with Rebekah’s mapping or similar setups? Are there additional steps I should take to enable the Shift Page functionality? Any help would be greatly appreciated!
Thanks in advance!
Chris