Traktor does not recognize two X1 MK2

karver_music
karver_music Member Posts: 2 Newcomer
edited October 22 in Traktor Software & Hardware

A month ago I bought two second hand X1 MK2 in perfect condition, in their boxes and with the keys. I have Traktor updated to the latest version but it does not detect the two X1 MK2. It is as if they both do the same function. I have tried rapping it in a few ways and still no way to get the four channels for my XONE 92. Can you think of a way to activate the two x1 MK2 independently. I don't even get the "default setap" section where the two should appear. I am desperate.

Tagged:

Best Answer

  • maniacintosh81
    maniacintosh81 Member Posts: 617 Guru
    Answer ✓

    In my installation no special steps were needed to use my two X1 Mk2. Just connected both to my MacBook (via a CalDigit Docking Station) and have to select my deck setup on every start of Traktor Pro. That's all and it works.

Answers

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 2,644 mod

    Try to manually add a second X1Mk2 default mapping using the 'Add…' button below the device dropdown, then assign it to the second X1Mk2.

  • karver_music
    karver_music Member Posts: 2 Newcomer

    Thanks for the answer.I tried that too but it does not distinguish the two x1's and does not recognize 4 channels.

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 2,644 mod

    @Stevan : Have you any experience with 2x X1Mk2? I don't have even a single one to test.

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,005 mod
    https://community.native-instruments.com/discussion/comment/153300#Comment_153300

    Nope, I only ever had a sngle X1 Mk2. Hopefuly somebody else can help here with testing.

    @karver_music - Can you please verify that you can select diferent deck configurations by turning an encoder after plugging in the USB cable to your second X1 Mk2?

  • maniacintosh81
    maniacintosh81 Member Posts: 617 Guru
    Answer ✓

    In my installation no special steps were needed to use my two X1 Mk2. Just connected both to my MacBook (via a CalDigit Docking Station) and have to select my deck setup on every start of Traktor Pro. That's all and it works.

This discussion has been closed.
Back To Top

Categories