Automating over a range of clips (MK3+Maschine software)
Hi, Is it possible to automate a filter (HP, LP etc) or make any automation over a range of selected clips in song mode ?
So when in song mode and i want to affect just a portion of clips (that may be from the same sketch patterns from ideas mode.
Example, I might have a drop or build up to a chorus and want make effects only in a certain range/time of the section. So rather than duplicate and re-record XYZ clips with effects - do it along a timeline i choose.
How can it be done?
Does that make any sense? I hope so and thanks for any advice.
you'll have to do some kind of automation, with FX that have a dry wet you just set it to dry, then automate it to wet, where the FX should start and back to dry where it should stop. Or automate frequency. Maybe with reaktor you could build something that reacts to note triggers, first note enable, second disables fx, that at first in a pad where you send audio to and behind fx you want.0
OP asks about how to proceed with automation in song mode itself, not which parameters to automate0
Yes Murat thanks, that's what I was asking. 👍️0
I know that, but there is no easy way to set a FX on for a selected range. And then i used that example.0
- 10.5K All Categories
- 20 Welcome
- 439 Hangout
- 58 NI News
- 203 Tech Talks
- 1K Native Access
- 4.8K Komplete
- 608 Komplete General
- 1.1K Komplete Kontrol
- 1.8K Kontakt
- 471 Reaktor
- 149 Battery 4
- 267 Guitar Rig & FX
- 198 Massive X & Synths
- 206 Other Software & Hardware
- 2.2K Maschine
- 14 Sampling Room
- 2.6K Traktor
- 2.3K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators