Two Pads, One Midi-Address
Hi,
I tried to create my own Maschine-Mapping to control Traktor-Remix Decks. But there´s a little Problem with the Midi-Address of two Pads.
In the first pcture, the red circled Pad in Group A and the (in the second picture) the red circled Pad of Group B are both "Ch. 1 Note D0" and i cannot rename one of those.
Does anyone have any advice
Thanks in advance
Best Answer
-
Hello,
Have you tried to go to the assign tab, there you can normally name all the pads and stuff.
0
Answers
-
Hello,
Have you tried to go to the assign tab, there you can normally name all the pads and stuff.
0 -
That was the first thing I tried, but I had to restart my PC to make it work. Thanks for this fast solution. :)
But now, I found the next problem:
I was setting the allignment of the buttons to the commands in my Traktor-Mapping by using the "Learn"-Function in Traktors Controller-Manager-Settings. Now there are many cases, where command is mapped to buttonand it shows the wrong address.
As you can see in my screenshot, I mapped the commandline "Slot 1 Cell 5 Trigger" to Pad "Ch1 C0" according to NI Controller Manager, but Traktor recognizes this Pad as "Ch1 C1".
Any advise, or do i have to adjust all wrong addresses by hand?
That could take some time... 😅
0 -
Have you maybe rearranged the midi notes and forgot to desable press, for traktor you definitely need to deactivate all press actions ,you only need hit.
0
Categories
- 12.3K All Categories
- 21 Welcome
- 560 Hangout
- 68 NI News
- 271 Tech Talks
- 1.2K Native Access
- 5.8K Komplete
- 753 Komplete General
- 1.3K Komplete Kontrol
- 2.1K Kontakt
- 565 Reaktor
- 185 Battery 4
- 314 Guitar Rig & FX
- 221 Massive X & Synths
- 269 Other Software & Hardware
- 2.6K Maschine
- 24 Sampling Room
- 3.1K Traktor
- 2.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators