So I just got a Maschine+ and it's awesome in most ways so far but one thing that confuses me is that I have not been able to use it as a poly aftertouch controller for external gear at all. If it didn't have the sensors that would be one thing, but when I go to controller mode and enter MIDI mode I can see in the monitor view that my pad presses have poly aftertouch data actively generating. What I can't seem to do is send it out over DIN MIDI (or even USB MIDI) or even select a specific channel to do so with.
It's not clear to me why MIDI controller mode can't select a DIN channel and send MIDI over it, much less the poly aftertouch data that is obviously there. I understand that full poly aftertouch recording/sequencing and using it on the internal synths will hit the CPU hard and might be tougher to implement, but it seems to me like it should be an obvious choice to allow these pressure sensitive pads to be used in both standalone and controller mode to send out PAT data over DIN MIDI. It also seems like a waste to have these sensors onboard that aren't being used to make the product better.
I've seen that inmusic said poly aftertouch support is still planned for Maschine+, is the use case I'm describing planned as part of it or will the Maschine+ just be able to receive PAT from other controllers?