TRAKTOR D2 - automatic reset of filters when loading the track

gianluca1974

Good morning everyone, as per the subject of this discussion, I would like to know if it is possible to automatically reset the filters (those present on the same knobs as the FX sends) when loading the track on the D2 controller, or how to map it to achieve this result; I recently purchased two D2 controllers. Thanks.

Find more posts tagged with

Accepted answers

All comments

Stevan

What you need are two modifiers. First one track which deck is selected and second one tracks if Browser mode is on and off.

Then map your filter reset on the Deck Load button.

Add In → Deck Common → Submix → Slot Filter adjust
type = button
mode = direct
value = 0.5

gianluca1974

Thank you so much for your prompt response. I tried, but the result is this: as soon as I touch the knob, the value resets. However, I would like the reset only when the track loads, and then have the knob function normally. Thank you very much.

Sûlherokhh

Don't map it to browser-touch. Map it to browser-push.

gianluca1974

Unfortunately, it doesn't work. The filter doesn't reset; it remains at the previous track's value. I did it this way: Add In → Deck Common → Submix → Slot Filter adjust
type = button
mode = direct
value = 0.5 and learn - browse encoder push.

Obviously, I selected the deck I'm interested in and the slot I'm interested in. Thanks again.

Stevan

Push, Diseble "Learn" and then let go of the encoder? It sounds like you still have assigned the touch CC.

Or, do you refer to moving filter encoders after resetting them to center position?

gianluca1974

I did it this way

Stevan

Let me test this on my D2 to be sure we are at the same page.

Stevan

Maybe you are testing on a wrong Deck? :)
It works as expected at my side.

gianluca1974

Hi, I'm testing on deck B and it's the correct one. However, I wanted to add the 'learn' button. It must be on when I configure, right? It's not clear from the screenshot I sent you, but the button was on. In summary, I would like the rotary controls for FX SEND and FILTER to automatically return to zero when a new track is loaded into the correct deck. Thanks a lot.

Sûlherokhh

https://community.native-instruments.com/discussion/comment/259878#Comment_259878

LEARN takes the very last input from your control. That means the moment you let go of the encoder, the device registers BrowseEnc-touch(release). But you want BrowseEnc-Press. LEARN will get in your way. You should select the encoder manually using the dropdown menu next to the LEARN button. Keep the LEARN button OFF.

Quick links

Unanswered questions