I have a very specific request that I don't know can be done
basically, what I would like to happen
If any pad is held, modifier #8 number changes to say it's held
if a pad is released whilst any other is still held, #8 modifier is still going to be unchanged and reporting it is held down
When all pads are released, depending on if deck flavour is either track or stem, the number #8 number will thus change to report if track or stem
what I have currently done:
- when on #1.0 (modifier for hotcue input and output) and pad 1 - 8 is pressed, modifiers will change to #6.1, #7.1 - # 7-7 respectively, this is unchanged* until A) another pad is pressed or B) is no longer on #1.0
*#6.1, #7.1 - #7.7 is also tied to changing the hotcue type with in my rane mapping thus cannot change the behavoir
2) when pad is pressed on modifier #6.1, #7.1-#7.7 and #8.0 or #8.6- change to #8.3
3a) when pad is released (invert) with modifier #6.1, #7.1-#7.7 and deck flavour is track, modifier #8.3 is changed to #8.0
Or
3b) when pad is released (invert) with modifier #6.1, #7.1-#7.7 and deck flavour is stem, modifier #8.3 is changed to #8.6
In my head there shouldn't be any conflict, however on repeated press with the same pad it does not change to #8.3 which tell me there's an issue with stage 2
here is a summary mapping, note that this was a test map, and I have since moved these commands with my intended rane tsi
