Stem Effects - Routing Effects to Individual Stems e.g. FX 1 to Bass & Other FX 3 to Vocals

Serge R

Hello, is there a way to route Effect 1 (freeze delay out) to delay out only Vocal Stem, and route Effect 3 (freeze delay out) to Bass and Other Stems?

To put it in perspective, I would like to be able to freeze delay out the "Bass" & "Other" Stems with FX 1, leaving the Vocal Stem playing with the Drum Stem, and then freeze delay out the Vocal Stem with FX 3.

Since both FX 1 and FX 3 are selected on the same deck, they interfere with each other.

Thank you.

Sûlherokhh

No. You can't apply separate FX to each sub channel. But you can activate (and attenuate, i.e. 'Dry/Wet') each sub channel's FX Send, which are all deactivated on your picture (see below).

Solution: Let the track run on two separate decks. I modeled this automation to isolate FX on high/mid/lo eq using duplicate decks using three eq kills divided among the two parallel running on-air tracks and applying FX only to one of the decks and it's un-killed eqs. Base for this F1 mod is TEKKEN's FX mapping (@DJTechTools-mapping page). It uses the Diplicate Deck assignment and i am not sure if the assignment works with stem tracks…. in short: full automation mapping is a bit complicated, but you can try by hand to see if the basic solution is sufficient for your needs.