Hello all, I am running into an issue attempting to connect a UMC1820\ADA8200 into a Maschine+ in Standalone mode. The 1820 and 8200 are connected with two ADAT cables, and everything appears to work OK into an iPad with AUM (all 20 input channels are recognized and pass signal when selected). If the setup is then plugged into a Maschine+, the 8 analog inputs and main out of the UMC1820 are available and operational, but the SPDIF in (input 9 and 10 of the 1820) and all 8 ins from the 8200 will not work when those inputs are selected in the Maschine+. The SPDIF and ADAT inputs appear to be selectable in Maschine+, but will not pass any signal when selected. I have not changed any configuration of the setup from when it worked in the iPad to when tried with the Maschine+. The Maschine+ has all firmware upgrades as of 09\06\25, and otherwise works well.
Can anyone suggest a configuration change or any other issue I could try to get the rest of the setup channels to work in the Maschine+? Or is it necessary to have the UMC1820 driver in the host to access SPDIF and ADAT (which is not possible in the Maschine+ standalone)? Thanks in advance for your help.
