Kontakt Player 6 not showing in Native Access

Ordinary_Mammal
Ordinary_Mammal Member Posts: 1 Noise

When clicking the link to download Kontakt Player 6, it gives you a field to type your email. This then sends you an email with this:

"Thank you very much for your interest in REAKTOR 6 PLAYER.

Here's how to download and install it:

1. DOWNLOAD/INSTALL NATIVE ACCESS

If you're new to Native Instruments, you first need to download/install Native Access via the link below:

Download NATIVE ACCESS

2. INSTALL REAKTOR 6 PLAYER

Once you've completed the Native Access installation and logged into Native Access, go to the 'Not Installed' section, where you'll find REAKTOR 6 PLAYER, ready to be installed.

Tip: Do you want free synths and sampled instruments? Download KOMPLETE START for free, including 2000 sounds and 6 GB of content."

I have uninstalled and reinstalled Native Access, I have restarted multiple times, I have signed up for the email again and I upgraded my OS.

Kontakt Player will not show up as being ready to install.


I do have the orignal Kontakt and Kontakt 5 installed but I only need the 6 Player to use something else that I purchased that runs on it.

Any ideas?

Best Answer

  • ShelLuser
    ShelLuser NetherlandsMember Posts: 133 Tri
    edited January 24 Answer ✓

    To my knowledge this is a limitation of Native Access, if you have a full version of Kontakt installed then you won't get to see any players. Same applies to Reaktor and Guitar Rig.

Answers

  • ShelLuser
    ShelLuser NetherlandsMember Posts: 133 Tri
    edited January 24 Answer ✓

    To my knowledge this is a limitation of Native Access, if you have a full version of Kontakt installed then you won't get to see any players. Same applies to Reaktor and Guitar Rig.

  • Jeremy_NI
    Jeremy_NI BerlinCustomer Care Posts: 641 mod

    Also note that if a third party library says it needs the Kontakt Player (free version) it will run on your Full version as well.

Back To Top