Izotope Ozone EQ 11: RTA questions

Mark Wesse

Simple question but how do you switch input modes for the RTA? ie pre post etc

Also, I work to K-System Ballistics which I can see I would like to modify as all my gain staging is done to -18 and would like to use the eq at head of chain and establish there…is there any other way to manange the graphics (I know release etc is there) as I would like an indicator bar at the -18 or someway to tell as its very difficult on 4k screens

Jeremy_NI

@Mark Wesse There is not currently a way to switch the EQ analysis between pre / post. It is always going to be post EQ.

There is a workaround however:

Ozone includes two EQ modules, so you can place one at the start of the signal chain and leave the EQ flat. The RTA in this first EQ will then read as Pre the second EQ module. Not a great workaround but could still be useful.

Uwe303

Hello,

You can't, as far a so know, it's always post eq. But maybe someone else knows better

Jeremy_NI

@Mark Wesse There is not currently a way to switch the EQ analysis between pre / post. It is always going to be post EQ.

There is a workaround however:

Ozone includes two EQ modules, so you can place one at the start of the signal chain and leave the EQ flat. The RTA in this first EQ will then read as Pre the second EQ module. Not a great workaround but could still be useful.