maschine3 out to maschine2 in

6xes

this may interest someone who has both versions of Maschine 2&3 software

basically you can "PLAY" the patterns on maschine 3… send the midi-out

and on the maschine 2 instance receive via midi-in without "play"(sitting idle) and load another kit which will be triggered by all the midi on maschine 3

set your midi-outs & press play (maschine3)

set midi-in on the other maschine2 instance (leave "play" off)

also on the maschine2 side turnoff the routings and patterns, so all the midi routings remain intact when changing kits

you can load in various kits on the maschine2 side and triggering will occur

for volume/midi control… you will need to adjust the volumes on the individual maschine instances….

take note the "mute" from the maschine3 midi-out….will stop midi ALL midi channel information being sent over, thus nothing will trigger

so you would adjust the instrument levels…. which allows the midi-channels to be sent over

6xes

one other peice of information

in the above example i was using the same apple iac virtual port

be sure when enabling your midi virtual port

enable "only" midi-input on side receiving

& "only" enable midi-output on the sending side, which is carried out in the maschine preferences