How can I connect and use a legacy KORE CONTROLLER to my M2 Mac?

orforrest
orforrest Member Posts: 2 Newcomer
in Other Software & Hardware

Hello!

This is probably a bit of a long shot, however…

I was gifted an old legacy NI KORE CONTROLLER by the owner of the studio I've been interning at, I know it's an old piece of gear but I've been going through a bit of an 'old gear' phase atm and wanted to see what I could do with it.

I have connected it via MIDI, it briefly lights up and then goes dark - I've searched everywhere for the correct drivers / software and it didn't connect to the NI control software. I also tried downloading the legacy NI controller editor but it doesn't seem to be compatible with the current version of my MacOS which is currently on Sonoma 14.1.1 (shock I know…)

Is there any possible work-arounds or ways I could make use of this hardware? It would be a shame to see it go to waste. I've got more hope than expectation but any advice would be appreciated!

Thanks

Tagged:

Best Answer

  • Kymeia
    Kymeia NKS User Library Mod Posts: 5,571 mod
    Answer ✓

    Sorry I wish you could but the problem would be the drivers were made for Intel based Macs and before things like SIP

Answers

  • Kymeia
    Kymeia NKS User Library Mod Posts: 5,571 mod
    Answer ✓

    Sorry I wish you could but the problem would be the drivers were made for Intel based Macs and before things like SIP

  • orforrest
    orforrest Member Posts: 2 Newcomer

    I thought as much, that's a shame - was worth a try! Thanks.

Back To Top

Categories