Read our community note - here.
Maschine + Plus freezes after update . How to downgrade?
Hi friends, I have updated my Maschine Plus to the latest version, and when I try to load the project I was working on, it freezes. The only solution is to re-boot it. I have a concert on Friday.
Please help me roll back to the previous version. Thank you.
Comments
-
Perhaps upgrading firmware to latest version 0.1.9 may help
How-to-Update-the-Firmware-of-Your-NI-Hardware
I suppose you need to connect M+ to computer with M+ power cable disconnected to get into controller mode in your case
From time to time i face similar problems with my projects too. What helps in my case:
- Just wait several minutes, M+ will reboot. Try loading the project, it may load this time. Repeat several times in case of failure.
- Or try loading different (smaller) project or several ones. After that problematic project usually loads fine.
- Or rollback to one of previous versions of the project, redo the same steps to achieve final result and then save the project with a new name. This new version can potentially be loaded just fine without any issues
- After successful load of problematic project, do some tweaks and save with a new name. Potentially it could help, but usually it doesnt
2 -
But the only real way to downgrade is to write to NI support. They can provide previous version installers
2 -
What was the version before upgrading?
Did you try transferring the Project to the computer and opening it with the Maschine 2 (2.17 or 2.18) desktop application?
0
Categories
- All Categories
- 19 Welcome
- 1.6K Hangout
- 66 NI News
- 842 Tech Talks
- 4.3K Native Access
- 17.3K Komplete
- 2.1K Komplete General
- 4.5K Komplete Kontrol
- 6K Kontakt
- 1.6K Reaktor
- 394 Battery 4
- 882 Guitar Rig & FX
- 446 Massive X & Synths
- 1.4K Other Software & Hardware
- 6.1K Maschine
- 7.7K Traktor
- 7.7K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators