Recording audio using line in connection

Backgammon
Backgammon Member Posts: 3 Newcomer

Hello happy NI users
I am intending to record sounds from my keyboard to Maschine. While the mic input is working fine on sampling, line 1 and 2 input show no incoming signal. Even though I have unplugged the mic input to get the line inputs working.
Any clue to make this works ?
Appreciate your help in advance πŸ˜‰ !
Jean-Michel

Tagged:

Best Answer

  • LostInFoundation
    LostInFoundation Member Posts: 5,121 Expert
    Answer βœ“

    Maschine Audio inputs aren’t the loudest.

    Are the recorded samples really inaudible? Have you tried using Normalize on them?

    If they are really very low after some manipulations, something must be wrong

Answers

  • LostInFoundation
    LostInFoundation Member Posts: 5,121 Expert

    Basic suggestions:

    Are those inputs assigned to something in Maschine audio routing?

    Are the gain knobs on the back raised?

    When in Sampling page, is Monitoring on? Are the meters showing inputs? Are the right Maschine Inputs selected as source?

  • Backgammon
    Backgammon Member Posts: 3 Newcomer

    Thank you for your quick reply and suggestions πŸ˜‰.
    Gonna check these on Maschine.

  • Backgammon
    Backgammon Member Posts: 3 Newcomer

    Finally the recording is acting using the line inputs but the output level is almost inaudible and this why I thought it was not working properly. Even though I set the Maschine audio input level at its max and the instrument level as well ? Any further suggestions ?

  • LostInFoundation
    LostInFoundation Member Posts: 5,121 Expert
    Answer βœ“

    Maschine Audio inputs aren’t the loudest.

    Are the recorded samples really inaudible? Have you tried using Normalize on them?

    If they are really very low after some manipulations, something must be wrong

Back To Top