Komplete Kontrol new installation

novak

Hello,

New iMac on Sonoma 14.7.2 and new Kontrol S88.

In Native access, Komplete Kontrol is installed. I can preview sounds from the app, but nothing can be triggers by my keyboard Kontrol…Any ideas?

Thank you

Jean

mykejb

Check the Preferences in Komplete Control, in the MIDI tab. It's likely that the S88 isn't enabled for input. Make sure the box is ticked then give it another go.

PoorFellow

https://community.native-instruments.com/discussion/42029/komplete-kontrol-new-installation

Check that the keyboard is set to Midi 1 ; Howto Switch a Kontrol S-Series MK3 Keyboard to MIDI 1.0

Else try the troubleshooters :

My Komplete Kontrol Keyboard Does Not Start

Kontrol S-Series MK3 Troubleshooting Guide

Kontrol S-Series MK3: Troubleshooting Firmware Update Issues

Also when using Mac with N.I. software then here is the standard things to generally check/do when using N.I. software ? :

ALL NI apps including NTKDaemon must have full disk access. : Howto Enable Full Disk Access on macOS and disks must be of correct format : Notes on Network Drives and Disk Formats

Also then please check that iCloud Private Relay has been turned off : Native Access Error Message: "Download failed" (macOS)

Also then do not use Clean My Mac.

And quote Kymeia : if using Sequoia then N.I. apps must be added to the Local Network

mykejb

Check the Preferences in Komplete Control, in the MIDI tab. It's likely that the S88 isn't enabled for input. Make sure the box is ticked then give it another go.

PoorFellow

https://community.native-instruments.com/discussion/42029/komplete-kontrol-new-installation

Check that the keyboard is set to Midi 1 ; Howto Switch a Kontrol S-Series MK3 Keyboard to MIDI 1.0

Else try the troubleshooters :

My Komplete Kontrol Keyboard Does Not Start

Kontrol S-Series MK3 Troubleshooting Guide

Kontrol S-Series MK3: Troubleshooting Firmware Update Issues

Also when using Mac with N.I. software then here is the standard things to generally check/do when using N.I. software ? :

ALL NI apps including NTKDaemon must have full disk access. : Howto Enable Full Disk Access on macOS and disks must be of correct format : Notes on Network Drives and Disk Formats

Also then please check that iCloud Private Relay has been turned off : Native Access Error Message: "Download failed" (macOS)

Also then do not use Clean My Mac.

And quote Kymeia : if using Sequoia then N.I. apps must be added to the Local Network

mykejb

If you can preview none of those suggestions are likely to be relevant. The MK3 works fine in KK when it's set to MIDI 2 mode. The keyboard starts and is working otherwise browsing wouldn't work.

PoorFellow

https://community.native-instruments.com/discussion/comment/208232#Comment_208232

I think that you got the preview wrong and the working browsing wrong , at least I comprehend what is written differently than you. Your previous settings suggestion might be right though.