Komplete Kontrol S88 MkII with Expression Pedals

docmeder

Does the S88 MkII run with an electro-harmonix expression pedal? The Configuration in the Komplete Kontrol SW is strange. In the manual there are two switches (Pedal A & Pedal B), in the software are two arrows (<&>) and both have the same configuration. When I switch between Pedal A & B there is the same content. Where is the problem?

Uwe303

Hello,

normally you set the pedal a or b to control chance them the cc number you want and from 0 -127 then it should work. I can't find those arrows in the s88 mk2 manual maybe you can make a picture. Or do you maybe refer to the arpeggiator snapshot part of the manual?

Uwe303

Hello,

normally you set the pedal a or b to control chance them the cc number you want and from 0 -127 then it should work. I can't find those arrows in the s88 mk2 manual maybe you can make a picture. Or do you maybe refer to the arpeggiator snapshot part of the manual?

docmeder

Hello,

These arrows are in the SW Version 3. And I tried again to configurate and set all the parameter first for pedal A (Sustain). Then I switched to pedal B and configurated it. When I switch back to pedal A, I see the configuration of Pedal B. That's my problem. Perhaps the Electro-Harmonix Pedal is the problem?

Uwe303

Ahh ok I see that's definitely not like it should be, have you tried to start komplete kontrol stand alone as administrator, maybe the keyboard does not take the settings somehow.