Controller List selection going off screen - Traktor Pro 4

dj_merlin

I've just upgraded my MacBook, and with that (is it an upgrade? No retina graphics…) to Traktor Pro 4 from Traktor Scratch 2 which has served me well over 10 years.

I implanted all of my collection and settings files into the directory folders, to make the switchover as seamless as possible.

I'm using a Korg Nanokontrol 2 controller to select and load tracks onto decks, which on the whole is working, but whenever my selection goes beyond the list of tracks, it disappears and I lose the ability to go back up the list (this is while using the Select Up/Down (Browser.List) midi command).

As an example, if I search for an artist, and use the controller to move down the list in increments of 4 tracks, if the 4 track jump goes beyond the end of the list, the selection highlight disappears, and I can't go back up the list from the bottom, I have to select from the top again and work my way down.

Far from ideal if trying to select tracks quickly whilst in the mix, and potentially then missing cue points by this delay. Any help would be greatly appreciated if anyone can think of a workaround, or if not, then NI - please sort this out as it's a right pain and a silly fault!

Stevan

Skipping tracks may indicate that multiple instances of the same mapping are installed? It is always good idea to screenshot your Devices list, In/Out ports and the assignment table when it comes to troubleshooting mappings.

dj_merlin

The issue isn’t that it’s skipping tracks in the list, it’s that when you go beyond the bottom of the list, it deselects any track and you have to start from the top.

Previously, when you hit the bottom of the list the selection would remain on the bottom track visible, allowing you to then navigate up from the bottom.

Here’s a little clip showing the issue - https://imgur.com/a/dYHzMVL

Unknown

This content has been removed.

Unknown

This content has been removed.