Maschine 3 for Maschine+ ?

Emma Air
Emma Air Member Posts: 1 Newcomer

I can’t find any information about, if the Maschine 3 update is running on the Maschine plus.

Is there some information, is there a plan to run it on the standalone mode. I guess the processing of stem separation could be way to much for the system built in the Plus, but on MPC the did. it. The quality is much worse then on the software running on computers but the did it.

Best Answer

  • tetsuneko
    tetsuneko Member Posts: 801 Expert
    edited November 2024 Answer ✓

    Maschine+ does not yet support 3.0 (Maschine Central which released with 3.0 does work though). OS update for M+ which brings 3.0 compatibility should be releasing soon (during Q4/24 or Q1/25 would be my guess)

    With regards to stem separation, I am not sure it is coming to M+ standalone.. but even if it does not come, you will be able to stem separate on the Maschine 3.0 desktop and then transfer the project back to standalone for further work

Answers

  • tetsuneko
    tetsuneko Member Posts: 801 Expert
    edited November 2024 Answer ✓

    Maschine+ does not yet support 3.0 (Maschine Central which released with 3.0 does work though). OS update for M+ which brings 3.0 compatibility should be releasing soon (during Q4/24 or Q1/25 would be my guess)

    With regards to stem separation, I am not sure it is coming to M+ standalone.. but even if it does not come, you will be able to stem separate on the Maschine 3.0 desktop and then transfer the project back to standalone for further work

Back To Top