Where are the stem samples?

gdiddy

Hello,

After using stem separation, a new group is opened. The stems are labeled as expected but no sound. When I hit Sampler it reads "Missing Sample" with a "Locate" button underneath. When I hit "Locate" the Maschine3 > Samples file opens up with nothing in it.

Any assistance on this issue would be greatly appreciated.

Jeremy_NI

Qiuick question @gdiddy what's the format of these samples? Are they mono by any chance? Mono files are not supported at the moment.

gdiddy

Jeremy_NI, I was recording in mono. I tried stereo and that did the trick. THANK YOU VERY MUCH!!!

LXNDR_BE

On Windows the Stem-Samples are normally autosaved in
<username>\Documents\Native Instruments\Maschine 3\Samples
(sorry can't test on Mac)
I tested it and deleted some files and M3 pointed me to the right folder.

Try opening the folder in Explorer (if you are on windows) and see if they are there.
If not, maybe there went something wrong with the installation - try reinstalling M3 SW from Native Access 2

Psyearth5

Do separation and then go to any steam to Sample Editor, right click and choose Show in Location.

gdiddy

Nothing has worked thus far.

D-One

Are you running Maschine in Admin Mode?

Jeremy_NI

Qiuick question @gdiddy what's the format of these samples? Are they mono by any chance? Mono files are not supported at the moment.

gdiddy

Jeremy_NI, I was recording in mono. I tried stereo and that did the trick. THANK YOU VERY MUCH!!!