Maschine Mikro Mrk3 and Logic X
Rhincocorn
Member Posts: 1 Newcomer
in Maschine
Hi all,
I've just bought Logic X with the hope of using it alongside the Mikro Mrk3 and am having some teething trouble setting it up. I've fully followed the steps in the Native Instruments setup video, which goes well until I switch the Maschine into MIDI mode, then I get no sounds or movement on the track waveforms. Strangely when I hit record and hit some pads I get a recorded passage which looks like this;
…but I can't hear anything when playing it or playing back. If I take it out of midi mode the waveforms move again and I can hear sounds.
Very much a newbie to Logic, Mikro and recording in general so any help would be appreciated. I see that this is a fairly common problem issue in getting the two things talking.
Thanks,
0
Back To Top
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 60 NI News
- 771 Tech Talks
- 4K Native Access
- 16.3K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.6K Kontakt
- 1.6K Reaktor
- 376 Battery 4
- 834 Guitar Rig & FX
- 425 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.7K Maschine
- 7.2K Traktor
- 7.2K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators