Maschine Mikro MK3 change midi cc

dst
dst Member Posts: 1 Newcomer
in Maschine

Hi, i want to control my viper vst with maschine mk3 using the touch strip for the cut off.

The problem: the touchstrip is midi cc 1 and controls the mod knob (mod wheel) in every vst.

can i change this behaviour, i just want to assign it with midi learn to the cut off in viper vst?

Best Answer

  • D-One
    D-One Moderator Posts: 3,627 mod
    Answer ✓

    If you're talking about MIDI Mode then you can assign any CC to the touch strip in Controller Editor.

    In Maschine Mode it controls whatever the buttons above tell it to, Pitch/Mod/PerformFX/Notes, for your usecase you can use the Mod Wheel mode and set your viper vst to use modwhell to control cut off.

Answers

  • Uwe303
    Uwe303 Moderator Posts: 4,213 mod

    Hello,

    you just open the controller editor software, then you can map everything as you need it.

  • D-One
    D-One Moderator Posts: 3,627 mod
    Answer ✓

    If you're talking about MIDI Mode then you can assign any CC to the touch strip in Controller Editor.

    In Maschine Mode it controls whatever the buttons above tell it to, Pitch/Mod/PerformFX/Notes, for your usecase you can use the Mod Wheel mode and set your viper vst to use modwhell to control cut off.

Back To Top

Categories