Where is the default output of the Patern player?
I am using Traktor Pro 4.02 on TK S3 and I have set the Patern Player on FX1. I have noticed two things:
- When I open Traktor Pro 4.02 I can hear the pattern player before Traktor fully loads. Is there a way to deactivate it?
- Sometimes the pattern player is audible through deck C and others on top of deck A! I haven't figured it out yet. Is there a way to set the output deck?
Best Answer
-
Hello,
the pattern player uses the insert fx as point to feed in audio, so you hear it where you activated the corresponding insert and if the fader is up (if you have your FX set pre fader in the settings not post!!). I never noticed the pattern player running while traktor starts but I will check it, maybe stop everything before you close traktor.
0
Answers
-
Hello,
the pattern player uses the insert fx as point to feed in audio, so you hear it where you activated the corresponding insert and if the fader is up (if you have your FX set pre fader in the settings not post!!). I never noticed the pattern player running while traktor starts but I will check it, maybe stop everything before you close traktor.
0 -
This content has been removed.
Categories
- All Categories
- 19 Welcome
- 1.4K Hangout
- 60 NI News
- 759 Tech Talks
- 4K Native Access
- 16.2K Komplete
- 2K Komplete General
- 4.2K Komplete Kontrol
- 5.6K Kontakt
- 1.5K Reaktor
- 371 Battery 4
- 830 Guitar Rig & FX
- 423 Massive X & Synths
- 1.2K Other Software & Hardware
- 5.6K Maschine
- 7.1K Traktor
- 7.1K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators