traktor 4 only works on 3 channels

massiisx
massiisx Member Posts: 2 Newcomer
edited October 22 in Traktor Software & Hardware 
Hi, I use Traktor connected to my V10 using all 4 Traktor docks, 
I don't understand why it only works with 3 decks, 
I also tried to attach the A10 audio card and it also only works with 3 decks, 
you too have this problem ?

Comments

  • lord-carlos
    lord-carlos Member Posts: 3,589 Expert

    It's a known bug.

    They are working on it.

  • massiisx
    massiisx Member Posts: 2 Newcomer 

    But the point of releasing it with this bug? 😡

Now I'm forced to use version 3 again until they release an update....😫

  • Sûlherokhh
    Sûlherokhh Member, Traktor Mapping Mod Posts: 2,827 mod

    Should be pretty soon. I assume NI development team had an ETA and stuck to a set of priorities. Secondary concerns to be addressed shortly after that. It was the same with many of the previous major feature updates.

  • red_nick
    red_nick Member Posts: 203 Advisor
    edited July 22
    https://community.native-instruments.com/discussion/comment/167352#Comment_167352

    Because holding up the update for the minority of users with 12+ audio channels would delay it for everyone else. That's why you should always read the patch notes:

    https://support.native-instruments.com/hc/en-us/articles/360017233958-What-s-New-in-Traktor-Pro-4

    And Traktor always keeps the old versions, so no problem going back while you wait.

  • lord-carlos
    lord-carlos Member Posts: 3,589 Expert

    @massiisx Can you update to 4.0.1 and see if that fixes your problem?

This discussion has been closed.
Back To Top

Categories