Problem linking synth to live input on traktor

MiguelDnB

Hello!

I am trying to link my TD-3 to Traktors Channel D so I can use it for some sets. I have been able to make the td-3 slave so I can start/pause it from Traktor Pro 3 and have it tempo sync.

The thing is regarding the input routing. I am using a presonus studio24c to insert the audio from the td-3 to the system and the main outs from the presonus to the line in of the Kontrol s3. I’ve also tried directly from the td-3.
I have also tried by using the presonus to send the master volume. I always have the same issue, which is that with every audio device (traktor s3 wasapi exclusive and shared and the studio24) when I go to input routing as I display the channel D it shows always “disabled” options. Also in the audio setup says “not supported”. I’ve tried in both the mic d and line (assuring they are ON) but I’m not able to get it right.

Please could you tell me a way to solve this issue and be able to use the synced td-3 with traktor on channel D.

Thanks!

Uwe303

Hello,

please use the asio driver, for lower latency and to have all inputs and outputs available (it depends also on the interface). Here is how to install the driver for the s3 on the bottom: https://support.native-instruments.com/hc/en-us/articles/360000520317-I-Cannot-Find-the-ASIO-Driver-for-My-TRAKTOR-KONTROL-S2-MK3-S4-MK3-S3-Windows

Uwe303

Hello,

please use the asio driver, for lower latency and to have all inputs and outputs available (it depends also on the interface). Here is how to install the driver for the s3 on the bottom: https://support.native-instruments.com/hc/en-us/articles/360000520317-I-Cannot-Find-the-ASIO-Driver-for-My-TRAKTOR-KONTROL-S2-MK3-S4-MK3-S3-Windows