Sample waveform view in editor has jitter (shaking/wiggling back and forth)

Options
Lawrence23
Lawrence23 Member Posts: 16 Member
edited October 2024 in Maschine

I have a new MK3 and the latest version of Maschine 2 software. I've just noticed the Sample waveform in the software editor jitters (shaking/wiggling back and forth) intermittently while all other parts of the UI are just fine. Is this a bug in the software? I did notice that it only does it when I select Sampling mode on the MK3, too. The problem goes away only when the software and the MK3 are not both in Sampling mode at the same time.

Comments

  • Lawrence23
    Lawrence23 Member Posts: 16 Member
    edited May 2024

    OK, I think I figured it out. It turned out that when the MK3 is in Sampling mode that encoder knobs 5 and 6 sometimes are transmitting signal even when not touched. So when I twisted them a few times the issue went away. Perhaps there was some dust in the encoders.

This discussion has been closed.
Back To Top

Categories