Connection Turntable with DJM 750 soundcard and no Audio 6!

FredM.
FredM. Member Posts: 4 Member
edited October 2024 in Traktor Software & Hardware

Hello everyone,

I have a question. I have been using Audio 6 for many years now, together with my Mac Book Pro, a DJM 750 (with USB connection) and two Technics turntables.

Now my question is:
I would like to decouple the Audio 6 and use the internal sound card from the DJM 750 (less cables). I have also downloaded and installed the driver for the DJM 750 from the Pioneer homepage. The software also shows that everything is connected. Now the question is:

What settings do I have to make in Traktor. The channels from the mixer remain in the USB position. What would be the input and output settings?

Best Answer

  • Owner
    Owner Member Posts: 575 Guru
    edited April 2024 Answer ✓

    Switch the in and outs from C / D with A / B

    0 / 1 for deck A and 6 / 7 for Deck B

Answers

  • lord-carlos
    lord-carlos Member Posts: 3,673 Expert

    Everything looks good. Do you have any issue?

  • Owner
    Owner Member Posts: 575 Guru
    edited April 2024 Answer ✓

    Switch the in and outs from C / D with A / B

    0 / 1 for deck A and 6 / 7 for Deck B

  • FredM.
    FredM. Member Posts: 4 Member

    Thank you so much .. but now i have the problem with Calbration failed but only on deck a.

  • Owner
    Owner Member Posts: 575 Guru

    Calibration problems can have various causes. Are both channels, i.e. left and right, coming in for deck A? You can see this in the Traktor settings in the inputs. Is the grounding connected? Is the buffer size, i.e. the latency, correct? Otherwise, do a cross-comparison with the needles and the record players. Swap the needles on your two players. Then you can also change the record players for the decks to narrow down the problem. Try connecting the right one to the inputs for deck A and the left one to the inputs for deck B.

This discussion has been closed.
Back To Top