Hanz Zimmer Perscussion with Mikro

Scoring
Scoring Member Posts: 1 Newcomer
edited October 2024 in Maschine

Hello! I have been trying to connect Hanz Zimmer Percussion pro to the Mikro!!!

I open logic pro, choose plug-in Kontakt 7 and i see the HZimmer software and i can play it with my midi keyboard but my mikro MK3 wont connect! Please any Suggestions?

Best Answer

  • bfarrellnz
    bfarrellnz Member Posts: 18 Member
    Answer ✓

    Are you using the Maschine plugin and loading it in there? Otherwise you will need to use it in MIDI mode to use as a controller. Not used that plugin, but you may need to open it in keyboard mode and play it chromatically on the pads if there is no Maschine kit, otherwise you need to map each pad in group mode to trigger the corresponding note in the group the plugin is loaded.

Answers

  • bfarrellnz
    bfarrellnz Member Posts: 18 Member
    Answer ✓

    Are you using the Maschine plugin and loading it in there? Otherwise you will need to use it in MIDI mode to use as a controller. Not used that plugin, but you may need to open it in keyboard mode and play it chromatically on the pads if there is no Maschine kit, otherwise you need to map each pad in group mode to trigger the corresponding note in the group the plugin is loaded.

  • Uwe303
    Uwe303 Moderator Posts: 4,145 mod
    edited March 2024

    Hello,

    as already said above, you could use the maschine plugin, load kontakt there and use keyboard mode on maschine but then you would record midi into maschine. I would use the maschine mikro in midi mode, then you play on the pads like a keyboard and the group pages are different note ranges/oktaves.

    https://support.native-instruments.com/hc/en-us/articles/115000864749-Recording-MIDI-Notes-in-Logic-Pro-X-from-MASCHINE-VIDEO

This discussion has been closed.
Back To Top