FX mode on Z1

BenELewis
BenELewis Member Posts: 3 Newcomer
edited October 2024 in Mapping Traktor

Hi. I’m using Traktor Pro 3 with a Z1 and despite pressing mode and On I can’t change to FX mode and get On switch to orange so I can use the FX.

Best Answer

  • lord-carlos
    lord-carlos Member Posts: 3,673 Expert
    Answer ✓

    I think that is only a Traktor Dj 2 thing.

    I made a mapping to use and change the mixer fx in traktor pro on the z1 controller though. It's somewhere on this forum.

Answers

  • lord-carlos
    lord-carlos Member Posts: 3,673 Expert

    Pressing mode just switches between two different kind of filters. One with more resonance and one more "pure"

  • BenELewis
    BenELewis Member Posts: 3 Newcomer

    Thx. What I’m trying to do is use the FX nob on the Z1 mixer to map to the FX I’ve chosen on the Pro 3 software for both decks but it just stays as a basic filter. Apparently the On switch on the Z1 should turn orange in order to do this but it doesn’t.

  • lord-carlos
    lord-carlos Member Posts: 3,673 Expert
    Answer ✓

    I think that is only a Traktor Dj 2 thing.

    I made a mapping to use and change the mixer fx in traktor pro on the z1 controller though. It's somewhere on this forum.

  • Stevan
    Stevan Traktor Mapping Mod Posts: 2,078 mod
    https://community.native-instruments.com/discussion/comment/137698#Comment_137698

    What does you mapping looks like :)

    Did you override factory setting for the filter buttons?

  • BenELewis
    BenELewis Member Posts: 3 Newcomer

    Thanks to you both. I feared this was the case. I will find the post on mapping. Thx.

This discussion has been closed.
Back To Top

Categories