Cannot use Cubase Pro and Dorico Pro at the same

Aloha,
I have a new Komplete A-49 which I really am loving, except I cannot operate both Dorico Pro 5 and Cubase Pro 12 at the same time. Either one by themselves is fine but if I have one open then start the other, one of them will not function (no input). I then have to restart the computer to regain functionality of the audio engine. At no time have I been able to use both. Any ideas about why this is happening?
Thanks in advance,
Comments
-
This will most probably be because the MIDI driver for the A-49 is a single client driver. Therefore you can only write to one source at a time, be it Cubase or Dorico. I don't believe that multi client drivers are available for a lot of kit even though many have been wanting these for a long time.
0 -
It's a rather unusual scenario to be running two DAWs at the same time.
Is this any use? https://hautetechnique.com/midi/midisplit/
0
Categories
- All Categories
- 19 Welcome
- 1.5K Hangout
- 62 NI News
- 788 Tech Talks
- 4.1K Native Access
- 16.6K Komplete
- 2K Komplete General
- 4.3K Komplete Kontrol
- 5.7K Kontakt
- 1.6K Reaktor
- 380 Battery 4
- 849 Guitar Rig & FX
- 429 Massive X & Synths
- 1.3K Other Software & Hardware
- 5.8K Maschine
- 7.3K Traktor
- 7.3K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators