Reaktor 6.5 (Full) unable to map channel aftertouch messages via MIDI Learn/Controllers pane

rickymanuk

I can map other controllers and MIDI notes, but not channel pressure messages - they simply don't show up for mapping from any keyboard. I have tried setting the display filter in the Controllers pane to All and to AT but it makes no difference.

Trying to set this up from the target control doesn't work either - the only available options are Controller, Note or Poly Aftertouch, but I want to use Channel Aftertouch.

This occurs in both standalone and VST versions on Macbook Air M1.

The AT messages are clearly being sent and received, since I can alter my Reaktor instruments and rewire things to handle pressure as intended. But that seems a bit of a drastic step.

Any reason why I can't just map AT from the Controllers pane?

Sunborn

https://community.native-instruments.com/discussion/21463/reaktor-6-5-full-unable-to-map-channel-aftertouch-messages-via-midi-learn-controllers-pane

There is a Channel Aftertouch in Reaktor for both midi in and midi out

Try this:

insert a Channel AT module into your instrument

then insert an IC Send module and connect it to the AT module you just created

switch the IC Send module to "Always Active"

switch the IC Send module to "Visible"

The IC Send module will give you a list about where to route the aftertouch. From this list, you can select any controller to receive the aftertouch signals.