Komplete Audio 6 MK2 mit Traktor Pro 3
Hello everyone,
I have recently started using the NI Komplete Audio 6 MK2 interface together with Traktor 3 Pro (version 3.8.0). I loaded the drivers via the Native Instruments page and selected them accordingly in the Audio Setup settings. From the sound card I then go to the club mixer via the outputs Out 1/2 and Out 3/4 with the appropriate cables (2x6.3 mm jack to 2x RCA) into 2 channels. Today I had a sound problem, after about 2 hours the sound of the sound card suddenly sounded strangely distorted in the middle of the song and the song seemed slightly slowed down, even though I hadn't changed anything in the driver settings. I then shut down the program and restarted it. After that it worked again, but I suspect I still set the wrong driver in the audio setup setting. Is there anything important to note here? Which driver do I use:
Komplete Audio 6 MK 2 (WASAPI (Shared Mode)) or Komplete Audio ASIO Driver (ASIO)?
Which buffer size (settings) should be set for the ASIO driver? 512 samples? Or more/less?
Do I have to pay attention to anything when setting up External Sync? Enable MIDI Clock Settings? Yes or no?
I suspect that I used the wrong driver (WASAPI (Shared Mode)) because I always had the ASIO driver set on my old Audio 4 DJ sound card. I just noticed it too. However, the (WASAPI (Shared Mode)) worked for about 2 hours, so I'm currently wondering what could have caused that? I would be very grateful for any help and tips! Best regards
Best Answer
-
Hello,
pls next time write in english, I translated it for you this time. So you are correct about the asio driver, you have to use that for a good audio performance. The buffer size could be smaller but you have to try, it depends on the cpu and overall performance of the computer. Hard to tell what can cause it without more information better analyzing it, there are many potential causes.
0
Answers
-
Hello,
pls next time write in english, I translated it for you this time. So you are correct about the asio driver, you have to use that for a good audio performance. The buffer size could be smaller but you have to try, it depends on the cpu and overall performance of the computer. Hard to tell what can cause it without more information better analyzing it, there are many potential causes.
0
Categories
- All Categories
- 19 Welcome
- 1.2K Hangout
- 58 NI News
- 630 Tech Talks
- 3.3K Native Access
- 13.9K Komplete
- 1.6K Komplete General
- 3.6K Komplete Kontrol
- 4.7K Kontakt
- 1.5K Reaktor
- 335 Battery 4
- 739 Guitar Rig & FX
- 382 Massive X & Synths
- 1K Other Software & Hardware
- 4.7K Maschine
- 6.1K Traktor
- 6.1K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators