X1 MK3 Mapping ist falsch gesetzt. Kann jemand helfen?

Robert J.
Robert J. Member Posts: 2 Newcomer
edited October 2024 in Mapping Traktor

Hello everyone,

Apparently the mapping (default setting) is set incorrectly on my new X1 MK3. I use Ableton, X1 MK3 and the DJM 900 NXS2.

The problem: If I set a loop in the X1 MK3 and adjust the treble in the DJM 900 NXS2, the loop function moves. I can't edit anything in the Ableton Preference - Controller Manager - Device - X1 MK3. Field empty!

Normally plug and play and the X1 MK3 should work.

For me the standard settings in the X1 MK3 seem to have been shot.

Can someone help? NI Support is unresponsive

P.S. translated by the mod Uwe303

Comments

  • Uwe303
    Uwe303 Moderator Posts: 4,205 mod
    edited October 2023

    Hallo,

    wie hast du denn alles verbunden und geroutet, du schreibst da was von Ableton wie ist das alles verbunden besonders Midi mäßig.

    Ohh sorry I'm a moderator and make a mistake myself - of course this forum is english only - the op uses the new X1 MK3 with ableton and has a mapping issue, I asked him how he has everything connected

  • lord-carlos
    lord-carlos Member Posts: 3,762 Expert

    You touch the djm and the loop changes?

  • Robert J.
    Robert J. Member Posts: 2 Newcomer
    edited October 2023

    Hello Uwe,

    Thank you for your feedback signal. I connected the DJM and X1 MK3 with a midi cable each. Say midi in usb-c (Mac) so I can control Ableton.

    P.S. Also translated by the mod Uwe303

  • lord-carlos
    lord-carlos Member Posts: 3,762 Expert

    So you are using it in midi mode with ableton. No traktor involved?

This discussion has been closed.
Back To Top

Categories