How can I set my remix decks up so I can hear them on my hardware mixer ?

spinray

Hi I want to use my remix decks as a jingle player over my DVS vinyl. I have Traktor4dj interface and traktor coded vinyl. I load my sounds into the remix decks but there is no sound from them coming through my mixer how can I reconfigure them to play through my hardware mixer over my dvs on my technics decks?

c0nsul

I guess you mean Audio4DJ and you use both stereo outputs to route Deck A and B into your mixer channels. To route Deck C and/or D into your mixer you will need another audio interface with more outputs when using external mixing mode in Traktor.

Don´t know if DVS works in internal mixing mode, in internal mixing mode you could channel A for master output and channel B for monitor output. But this would make your hardware mixer obsolete as mixing is then done inside Traktor.

spinray

yes sorry meant Audio4DJ . I had the same problem in Mixxx software I got round that by routing the decks So instead if Deck 1+2 outputs you could send Left/Right Bus to your mixer and assign samplers (remix decks in this case) to either side of the crossfader. Is this possible in Traktor or could I use a second soundcard I have a little behringer one.

c0nsul

https://community.native-instruments.com/discussion/comment/98728#Comment_98728

AFAIK the routing you mention is not possible in Traktor.

Traktor only allows the use of one interface. So, you could combine the Behringer interface and Audio4DJ to a virtual interface (on Mac "aggregated device") and use it as Traktor audio interface. But this may increase latency.