Wavetable Inharmonic Mode Query

Noise Native
Noise Native Member Posts: 26 Member
edited October 22 in Scripting Workshop

Hi, I hope this query finds you well.

I’ve been using the Wavetable Inharmonic Mode and scripting it into my instruments via the $ENGINE_PAR_WT_INHARMONIC_MODE command which turns the mode on/off, but I am wondering if there is also a specific command for the percentage value? I can’t find it in the manual so it might not be available, but you never know there might be a secret cheat-code ;) Or I might have missed it! If it is not available at present are there any plans to add it?

Thank you.

Comments

  • corbo-billy
    corbo-billy Member Posts: 101 Helper

    $ENGINE_PAR_WT_INHARMONIC

  • Noise Native
    Noise Native Member Posts: 26 Member

    Great! Thank you corbo-billy, I’ll test it as soon as possible. I couldn’t find that specific command in the manuals.

  • corbo-billy
    corbo-billy Member Posts: 101 Helper
    edited August 2023

    I find it in the KSP manual (Engine Parameter chapter, Source & Module)_

  • Noise Native
    Noise Native Member Posts: 26 Member

    Thank you again! Page 269 (in a newer version of the KSP pdf manual that I had been using).

  • Noise Native
    Noise Native Member Posts: 26 Member

    Works perfectly, thank you corbo-billy :)

  • corbo-billy
    corbo-billy Member Posts: 101 Helper

    _Super _ 😎

This discussion has been closed.
Back To Top

Categories