Reaktor 6 continuous sound output without a input

GStephens

I am trying to build in reaktor 6 and my computer keyboard is recognized as a midi controller but whenever I try to build in reaktor it just plays continuous sound and does not stop when I take my finger off a key. I have added envelopes and removed the note in utility but it just keeps playing. I have added a screenshot where you can see fl picking up input but note in util is disconnected and I am not playing anything else.

I would appreciate any help if someone has run into this before.

Sunborn

https://community.native-instruments.com/discussion/14705/reaktor-6-continuous-sound-output-without-a-input

Usually you don't create ensembles and block in FL Studio or in any other DAW.

You create them in Reaktor stand-alove and then you play (or tweak) them in your DAW.

Maybe this is the problem

Or most probably that your Note In block is not connected to any gate (or pitch)

colB

https://community.native-instruments.com/discussion/14705/reaktor-6-continuous-sound-output-without-a-input

Turn the level knob on the VCA to zero (fully anti-clockwise). It's like a manual level control, so you get sound all the time when it's turned up.

With this done, you will only get sound when the envelop modulates that control via the A/B mod system.

Paule

It sounds like a selfoscillation of the filter. Lower the Cutoff please.

colB

https://community.native-instruments.com/discussion/comment/82289#Comment_82289

That would only be an issue with high resonance, and even then, the VCA would shut it off.

When I use that filter, I often have cutoff at maximum and resonance low - it lets the sound through relatively unaltered, so you can A/B without rewiring. It's never a problem!

gentleclockdivider

https://community.native-instruments.com/discussion/comment/82214#Comment_82214

Uhh , I do this all the time , building with the vst version of reaktor .

Both blocks , core , primary

gentleclockdivider

It seems that no one has actually looked at the posted screenshot , it's pretty obvious what's going on .

There is not gate connected from'note out module ' to the env. in , and the amp module gain slider is all the way up ,no wonder there is a continous output .

If the envelope is not triggered , the amp will remain open (if it's open to begin with , which it is ).

So , route 'note out gate' to 'gate in' of envelope , route envelope out to mod index 1 of the amp module and move this ( index ) all the way up , move amp down .

Sunborn

https://community.native-instruments.com/discussion/comment/83276#Comment_83276

I see your screenshot, i even downloaded it to zoom in for better details. But you didn't payed attention to what i wrote in my previous comment:

your Note In block is not connected to any gate

What you call "note out module" is actually the Note In module... "Note Out" module, does not exist... ^_^