Xone 23C & Traktor Pro 3

Shute

Hi everyone, I'm kind of new to this.

First of all my equipment is: Xone 23c, two traktor x1 and f1 controllers, some monitors connected by xlr to the xone23c, windows 11 and traktor pro 3.

My problem is the following: in traktor I work with 2 decks ( A and B) and 2 remix decks. I can play in traktor on channels A and B but then the sound comes out to my mixer only through channel A, whatever I do in the inputs and outputs it still comes out through channel A of the Xone 23. I don't know if I need any driver of the Xone23c or configure well the inputs and outputs of traktor. I hope help please.

lord-carlos

You have external mixing selected in the config?

Please show us the output routing settings inside traktor.

Stevan

Sounds like you are using the USB interface in the mixer? if so, that is a single l/r channel for recording.

Any external audio interfaces?

Shute

Hi guys, that problem is solved, but now I have another one.

I don't have any external audio interface, only the one integrated in the xone 23c with 4 stereo channels. 

To get the sound of the f1 from the remix deck (channel C in Traktor Pro) I can only get it out of one of the two channels of the Xone23c, mixing it with the track that may be playing. I would like to send the sound directly to the master without having to go through one of the channels of the external mixer. I would like it to sound independent. I have seen that it is possible with the Z1 for example. I don't know if you could answer my question, thanks.

IMG-1176.jpg

IMG-1175.jpg

Stevan

I thought it was only 2 stereo channels. Thanks for the heads up!

Maybe switch to Internal Mixing mode and then map some knobs to control the volume.

lord-carlos

To get the sound of the f1 from the remix deck (channel C in Traktor Pro) I can only get it out of one of the two channels of the Xone23c

I'm not sure it's possible. The 23c has only the 2 stereo channels. You send both decks to it and the mixer does it's thing. If you want 4 there is the Xone 43c.

https://community.native-instruments.com/discussion/comment/54322#Comment_54322

But then you have a nice xone mixer that people like for the filters and resonance selection thingy and use it as a controller :S

lukypanchitos

https://community.native-instruments.com/discussion/comment/54311#Comment_54311

how did you solved that first problem??? i have the same :(

lord-carlos

https://community.native-instruments.com/discussion/comment/87454#Comment_87454

Select external mixing mode and route deck a to channel 1 and 2, and deck b to 3 and 4.