Problem driver x1 mk1

Options
Lor3nzo
Lor3nzo Member Posts: 3 Newcomer
edited October 2024 in Traktor Software & Hardware

I’ve a peoblem with my instrument x1 mk1.

i try to install driver on mac os ventura 13.2 but it doesn’t work , the installation failded for “a problem”.

Best Answers

  • Markovicz
    Markovicz Customer Care Posts: 381 mod
    Answer ✓

    Hi @Lorenzo,

    it's very sad but equally true: the X1 MK1 is not compatible with any macOS higher than 10.14 - unless the system has been subsequently being updated from that point on. No chance on newer Macs...

  • lord-carlos
    lord-carlos Member Posts: 4,171 Expert
    edited September 2023 Answer ✓

    I only see one of these options.

    • Downgrade your Mac OS
    • Switch to windows
    • Buy a used X1 mk2
  • Markovicz
    Markovicz Customer Care Posts: 381 mod
    Answer ✓
    https://community.native-instruments.com/discussion/comment/96760#Comment_96760

    There once was a blog that showed a very hacky way to run legacy NI hardware that requires a kernel driver on macOS 10.15 and higher. This blog entry does no longer exist, so I cannot even point to that solution. It was not at all supported anyway, and would have been 100% on a user's own risk.

    So should you come across such instructions anywhere, please keep that in mind.

Answers

  • Markovicz
    Markovicz Customer Care Posts: 381 mod
    Answer ✓

    Hi @Lorenzo,

    it's very sad but equally true: the X1 MK1 is not compatible with any macOS higher than 10.14 - unless the system has been subsequently being updated from that point on. No chance on newer Macs...

  • Lor3nzo
    Lor3nzo Member Posts: 3 Newcomer

    Is possibile in anyway to use it with my Mac Ventura?

  • lord-carlos
    lord-carlos Member Posts: 4,171 Expert
    edited September 2023 Answer ✓

    I only see one of these options.

    • Downgrade your Mac OS
    • Switch to windows
    • Buy a used X1 mk2
  • Markovicz
    Markovicz Customer Care Posts: 381 mod
    Answer ✓
    https://community.native-instruments.com/discussion/comment/96760#Comment_96760

    There once was a blog that showed a very hacky way to run legacy NI hardware that requires a kernel driver on macOS 10.15 and higher. This blog entry does no longer exist, so I cannot even point to that solution. It was not at all supported anyway, and would have been 100% on a user's own risk.

    So should you come across such instructions anywhere, please keep that in mind.

This discussion has been closed.
Back To Top

Categories