pitch a sound to a hundredth of a tone

Options
Cren Larvor
Cren Larvor Member Posts: 58 Member
edited October 2024 in Maschine

hello community, is it possible on maschine to pitch a sound to a hundredth of a tone? I see there is a feature to go from semitone to semitone, but no more precise feature. Is this really the case?

Thanks

Tagged:

Best Answer

  • D-One
    D-One Moderator Posts: 3,772 mod
    edited May 2023 Answer ✓

    Assuming you're talking about the Sampler the above works but its a bit of extra work depending on the scenario.

    The regular Tune parameter can also be modified in fine steps by holding shift, from the software or from the controllers; wherever it makes sense Shift can usually be used for fine steps.

    100th would be 0.10 or 0.01, not sure I am bad at math 🥲

    Screenshot 2023-05-21 183403.png


Answers

  • darkwaves
    darkwaves Member Posts: 477 Guru

    I'm not quite sure what 100th of a tone would mean, but you have finer control over in the zones tab of the sampler.

    image.png


  • D-One
    D-One Moderator Posts: 3,772 mod
    edited May 2023 Answer ✓

    Assuming you're talking about the Sampler the above works but its a bit of extra work depending on the scenario.

    The regular Tune parameter can also be modified in fine steps by holding shift, from the software or from the controllers; wherever it makes sense Shift can usually be used for fine steps.

    100th would be 0.10 or 0.01, not sure I am bad at math 🥲

    Screenshot 2023-05-21 183403.png


  • Cren Larvor
    Cren Larvor Member Posts: 58 Member

    Hi D-One and Darkwaves, the mail notifications was on my spam sorry.

    I'm not good at math either, but the two ways work perfectly well ;)

    Thanks a lot for your help 🙏

This discussion has been closed.
Back To Top

Categories