Maschine Jam does not sync up with Maschine studio - piano roll/step sequencer

CakeAlexS
CakeAlexS Member Posts: 34 Member

Hi

Please check the video commentary. One thing I forgot to state, with both controllers the notes/events show up in the software as normal.

Windows 11 / Maschine 3.2

Thx!

Best Answer

  • CakeAlexS
    CakeAlexS Member Posts: 34 Member
    Answer ✓

    Actually no I didn't think of this, a good suggestion, however it turns out it isn't required at least in Windows (I don't need to set MIDI at all in preferences for these controllers it just picks it up).

    Turns out it's my misunderstanding, each controller was working on different pitch notes (of course - doh!). If you look at the video I'm programming steps for different pitches.

    So if I sync up the same pitch note between controllers it works.
    There is however something peculiar going on and I can't quite fathom it. I guess I will post once I can get my head around it (assuming it is an issue rather than my misunderstanding).

    Thx!

Answers

  • CakeAlexS
    CakeAlexS Member Posts: 34 Member

    Follow up video to show the software behaviour. Note there is nothing wrong with this, I show this just for further info.

  • CakeAlexS
    CakeAlexS Member Posts: 34 Member

    So anybody else have this issue.

    I've tested Maschine Studio 3.2/Jam/Windows 11 combinations.

    Interested to know if others can repro with these specs (I suspect they can), and whether Mac/MK3 controllers have the same issue with Jam.

  • 6xes
    6xes Member Posts: 918 Guru

    does selecting both Studio&Jam in midi input/output within preferences fix the issue?

  • CakeAlexS
    CakeAlexS Member Posts: 34 Member
    Answer ✓

    Actually no I didn't think of this, a good suggestion, however it turns out it isn't required at least in Windows (I don't need to set MIDI at all in preferences for these controllers it just picks it up).

    Turns out it's my misunderstanding, each controller was working on different pitch notes (of course - doh!). If you look at the video I'm programming steps for different pitches.

    So if I sync up the same pitch note between controllers it works.
    There is however something peculiar going on and I can't quite fathom it. I guess I will post once I can get my head around it (assuming it is an issue rather than my misunderstanding).

    Thx!

Back To Top