Select/deselect multi channels on Maschine Studio

CakeAlexS · 2025-06-20T20:16:40+00:00

There was an error rendering this rich post.

On the Maschine 3.2 application I can go to the mixer view and multi-select and deselect channels by clicking on them and holding the shift button or control button or CTRL-A or whatever. They will turn light grey when selected, and when I move one fader, all the selected channel faders with all move at the same time. Fine.

How do I do this in Maschine Studio controller?

I'm finding quite often they are all selected in the mixer, which screws up my workflow, and the only way to deselect them all is to return to the application and deselect them all with my mouse.

If only one channel is selected, I can just select them with the white buttons at the top of the controller, no problem here. This question is specifically to do with multi-select.

Thx.

(Windows)

Find more posts tagged with

Maschine Studio

Maschine 3 SW

Accepted answers

6xes

i think… what you need to do… going from how i do it on the maschine mk2

select the group you want

you hold "select" then all the sounds slots should show up… at which point you can press the pads

you should also be able to pin the select button.. so that you dont need to hold the select button

CakeAlexS

OK thanks worked it out after what you suggested.
When I held down "Select" I should have paid attention to "Multi" (button 8) and then I can select by group.

Much appreciated!

All comments

6xes

i think… what you need to do… going from how i do it on the maschine mk2

select the group you want

you hold "select" then all the sounds slots should show up… at which point you can press the pads

you should also be able to pin the select button.. so that you dont need to hold the select button

CakeAlexS

Thanks, I held down the select button previously, maybe I didn't press the group buttons! (which would make sense).

I'll check it out will provide feedback (might be a while).. Appreciated!

CakeAlexS

OK thanks worked it out after what you suggested.
When I held down "Select" I should have paid attention to "Multi" (button 8) and then I can select by group.

Much appreciated!

Quick links

Unanswered questions