Send effects and and Live input

macgregor · May 2022

I own a Mac M1 with Monterey with an Audio 10 sound card, a PlayDifferently mixer and a Euroroack modular.

I've been following the instructions to get the send effects from the mixer fx loop to route through the Traktors send effect but I can never get Traktor to output any audio. The Audio 10 is showing there is an input signal and when I set the audio 10 to "through" mode I get sound going to the right return. It just gets stopped when I have it set up like the directions say it should be set up.

The live input is also silent.

When I open the audio/midi setup "audio window" all the channel volumes for the audio 10 are greyed out. I feel like this is causing the issue but nowhere can I find to get them to become normal.

It seems like the audio to just isn't letting audio through into traktor.

Everything else works flawlessly.

Does anyone have any advice?

macgregor · May 2022

I solved the issue.

Under security and privacy, in the privacy section I had to enable Traktor to access the microphone.

Then it all started working flawlessly.

macgregor · May 2022

I solved the issue.

Under security and privacy, in the privacy section I had to enable Traktor to access the microphone.

Then it all started working flawlessly.

Ryan_NI · May 2022

thanks for sharing your solution with us! having the microphone permissions set is one that comes up quite frequently. for anyone else that runs into this issue, check out the link below:

Send effects and and Live input

Best Answer

Answers

TRAKTOR Does Not Receive Audio or Timecode Signal with macOS 10.14 (Mojave) and Higher

Categories