Maschine Mikro MK2 and Pro Tools 2022.10 Windows

DDmUSA
DDmUSA Member Posts: 33 Member
edited October 2024 in Maschine

I connected the Maschine Mikro MK2 controller to a Windows 11 laptop running Pro Tools 2022.10. I tried putting Kontakt on an instrument track to use the Tambourine (Funky) Single Instrument. I could not figure out how to get the Mikro controller to send the correct corresponding note to Pro Tools.

Can someone please provide step-by-step instructions to get the Mikro controller to send specific notes from the controller pads to Pro Tools? For example, if I want one of the pads on the Mikro to send a specific F# note, how do I do this?

Tagged:
This discussion has been closed.
Back To Top

Categories